Category Archives: Hazardous Location

New product on our website: Chromalox CXH-A/B Fan forced unit heater certified for use in hazardous locations.

New product on our website: Chromalox CXH-A/B Fan forced unit heater certified for use in hazardous locations.

http://www.morelectricheating.com/products/MANUFACTURERS/CHROMALOX/CHROMALOX%20AIR/CXH.aspx

CXH-A/B Fan forced unit heater certified for use in hazardous locations.
• 3-35 kW (10,200-119,420 Btuh) Power Ratings
• 208V-600V, Single and Three Phase Voltages Available
• cULus listed for Class I, Division I, Groups B, C, D
• ATEX/IECEx II2G Exd IIB T3 and EAC Certifications Available

The CXH-A fan-forced explosion proof unit heater is designed to heat areas classified as hazardous locations to provide primary or supplementary heating for comfort or freeze protection.

New Product: Dimplex DX-233 Series Explosion Proof Industrial Heater. 24VAC Transformer. 208 & 240(1&3Ph), 480 & 600V(3Ph)

Dimplex DX-233 Series Explosion Proof Heater


Heavy duty industrial unit heaters featuring T3C ratings – the lowest ignition temperature rating in the industry! The DX-233 Series heaters are offered in a wide range of power outputs, voltage ratings and available control systems for custom tailoring to your needs. Dual (automatic and manual reset) over-temperature protection incorporated with a 70 PSIG relief value setting for additional user safety. A welded steel heat exchanger with painted steel heaters, steel tubes, and spiral wound aluminum fins for extra unit durability. Ideal for environments where there is a risk of vapour or dust combustion.

Finish:
Baked on polyester powder-coated cabinet; epoxy covered motor; NEMA 7, 9 cast aluminum control circuit enclosure. Also available in 316 stainless steel or Heresite® construction. Contact factory for information.

Heating Element:
Welded steel heat exchanger with painted steel heaters, steel tubes and spiral wound aluminum fins

Heat Exchanger:
The advanced design allows lower operating temperatures from sealed liquid-to-air heat exchanger with steel tubes, and integral aluminum fins. The pressure relief device provides excel pressure protection.

Controls & Wiring:
24VAC transformer; contactor; with automatic and manual reset over temperature thermal cut-outs. Adjustable covers.

 

 

Features


  • T3C ratings
    Lowest ignition temperature code rating in the industry: T3C, 320F
  • Dual over-temperature protection
    Automatic and manual reset cutout for additional safety
  • Nontoxic Heat Transfer Fluid
    Allows lower operating temperatures
  • Low 70 PSIG relief valve setting
    Assures initial escaping vapor temperature remains below 320F ignition point
  • Modular design
    Built for use in dry non-corrosive areas

http://www.morelectricheating.com/products/MANUFACTURERS/ELECTROMODE@@2fDIMPLEX/DX-233.aspx